Maxtor DiamondMax 21 Spezifikationen

DiamondMax 21200 - 320GBATANovember 2006PN: 100435213

2 DiamondMax 21 PATA Product Manual, Rev. A

DiamondMax 21 PATA Product Manual, Rev. A 32.0 Drive specificationsUnless otherwise noted, all specifications are measured under ambient conditions, a

4 DiamondMax 21 PATA Product Manual, Rev. ATable 1: Drive specifications summary for the 320 Gbyte modelDrive specification STM3320820AFormatted Gby

DiamondMax 21 PATA Product Manual, Rev. A 5Vibration, operating 5–22 Hz: 0.25 G, Limited displacement22–350 Hz: 0.50 G350–500 Hz:: 0.25 GVibration, no

6 DiamondMax 21 PATA Product Manual, Rev. ATable 2: Drive specifications summary for the 300 Gbyte modelDrive specification STM3300620AFormatted Gbyt

DiamondMax 21 PATA Product Manual, Rev. A 7Vibration, operating 5–22 Hz: 0.25 G, Limited displacement22–350 Hz: 0.50 G350–500 Hz:: 0.25 GVibration, no

8 DiamondMax 21 PATA Product Manual, Rev. ATable 3: Drive specifications summary for 250 Gbyte modelsDrive specification STM3250820A STM3250620AForma

DiamondMax 21 PATA Product Manual, Rev. A 9Vibration, operating 5–22 Hz: 0.25 G, Limited displacement22–350 Hz: 0.50 G350–500 Hz:: 0.25 GVibration, no

10 DiamondMax 21 PATA Product Manual, Rev. ATable 4: Drive specifications summary for the 200 Gbyte modelDrive specification STM3200820AFormatted Gby

DiamondMax 21 PATA Product Manual, Rev. A 11*One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary de

© 2006, Maxtor Corporation All rights reservedPublication number: 100435213, Rev. ANovember 2006Maxtor and MaxFax are registered trademarks of Maxtor

12 DiamondMax 21 PATA Product Manual, Rev. A2.2 Formatted capacity*One Gbyte equals one billion bytes when referring to hard drive capacity. Accessibl

DiamondMax 21 PATA Product Manual, Rev. A 132.4 Recording and interface technology 2.5 Physical characteristics320GB 300GB 250GB 200GBInterface ATARec

14 DiamondMax 21 PATA Product Manual, Rev. A2.6 Seek timeSeek measurements are taken with nominal power at 25°C ambient temperature. All times are mea

DiamondMax 21 PATA Product Manual, Rev. A 15• Idle mode powerIdle mode power is measured with the drive up to speed, with servo electronics active and

16 DiamondMax 21 PATA Product Manual, Rev. A2.8.1.1 Typical current profileFigure 1 Typical 5V startup and operation current profileFigure 2 Typical

DiamondMax 21 PATA Product Manual, Rev. A 172.8.3 Voltage toleranceVoltage tolerance (including noise):5V ± 5% 12V ± 10%2.8.4 Power-management modesTh

18 DiamondMax 21 PATA Product Manual, Rev. A2.9 Environmental specifications2.9.1 Ambient temperatureAmbient temperature is defined as the temperature

DiamondMax 21 PATA Product Manual, Rev. A 192.9.5 ShockAll shock specifications assume that the drive is mounted securely with the input shock applied

20 DiamondMax 21 PATA Product Manual, Rev. A2.10 AcousticsDrive acoustics are measured as overall A-weighted acoustic sound power levels (no pure tone

DiamondMax 21 PATA Product Manual, Rev. A 212.11 Electromagnetic immunityWhen properly installed in a representative host system, the drive operates w

DiamondMax 21 PATA Product Manual, Rev. A i

22 DiamondMax 21 PATA Product Manual, Rev. A2.12 Reliability2.12.1 Annualized Failure Rate (AFR and Mean Time Between Failures (MTBF) The product shal

DiamondMax 21 PATA Product Manual, Rev. A 23Korean RRLIf these drives have the Korea Ministry of Information and Communication (MIC) logo, they comply

24 DiamondMax 21 PATA Product Manual, Rev. A2.14.1 European Union Restriction of Hazardous Substances (RoHS)The European Union Restriction of Hazardou

DiamondMax 21 PATA Product Manual, Rev. A 253.0 Configuring and mounting the driveThis section contains the specifications and instructions for config

26 DiamondMax 21 PATA Product Manual, Rev. A3.2 Breather filter hole precautionsThis section contains information regarding the precautions which shou

DiamondMax 21 PATA Product Manual, Rev. A 273.3 Jumper settings3.3.1 Master/slave configurationThe options jumper block shown in Figure 4 is used to c

28 DiamondMax 21 PATA Product Manual, Rev. A3.3.3 Ultra ATA/100 cableAn 80-conductor 40-pin cable is required to run Ultra DMA mode 3, mode 4, and mod

DiamondMax 21 PATA Product Manual, Rev. A 29Figure 6 Mounting dimensionsNotes:1. Dimensions are shown in inches (mm).2 Dimensions per SFF-8301 speci

30 DiamondMax 21 PATA Product Manual, Rev. A

DiamondMax 21 PATA Product Manual, Rev. A 314.0 ATA interfaceThese drives use the industry-standard ATA task file interface that supports 16-bit data

ii DiamondMax 21 PATA Product Manual, Rev. A

32 DiamondMax 21 PATA Product Manual, Rev. A4.1.1 Supported ATA commandsThe following table lists ATA-standard commands that the drive supports. For a

DiamondMax 21 PATA Product Manual, Rev. A 33Security Erase Unit F4HSecurity Freeze F5HSecurity Set Password F1HSecurity Unlock F2HSeek 70HSet Features

34 DiamondMax 21 PATA Product Manual, Rev. A4.1.2 Identify Device commandThe Identify Device command (command code ECH) transfers information about th

DiamondMax 21 PATA Product Manual, Rev. A 3560–61 Total number of user-addressable LBA sectors available(see Section 2.2 for related information)*Note

36 DiamondMax 21 PATA Product Manual, Rev. ANote. Advanced Power Management (APM) and Automatic Acoustic Management (AAM) features are not supportedNo

DiamondMax 21 PATA Product Manual, Rev. A 374.1.3 Set Features commandThis command controls the implementation of various features that the drive supp

38 DiamondMax 21 PATA Product Manual, Rev. A4.1.4 S.M.A.R.T. commandsS.M.A.R.T. provides near-term failure prediction for disc drives. When S.M.A.R.T.

DiamondMax 21 PATA Product Manual, Rev. A 395.0 Maxtor support servicesBefore contacting Maxtor Support, use the Hard Disk Information feature in MaxB

40 DiamondMax 21 PATA Product Manual, Rev. A

DiamondMax 21 PATA Product Manual, Rev. A 41IndexAacoustics 20Active mode 17AFR 22agency certification (regulatory) 22altitude 18ambient con

DiamondMax 21 PATA Product Manual, Rev. A iiiContents1.0 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

42 DiamondMax 21 PATA Product Manual, Rev. AIdle and Standby timers 17Idle Immediate 32Idle mode 17Idle mode power 15IEC950 22Information Te

DiamondMax 21 PATA Product Manual, Rev. A 43SS.M.A.R.T. commands 38S.M.A.R.T. Disable Operations 33S.M.A.R.T. drive monitoring 1S.M.A.R.T. Enabl

44 DiamondMax 21 PATA Product Manual, Rev. A

Maxtor Corporation920 Disc Drive, Scotts Valley, California 95066-4544, USAPublication Number: 100435213, Rev. A, Printed in U.S.A.

iv DiamondMax 21 PATA Product Manual, Rev. A

DiamondMax 21 PATA Product Manual, Rev. A vList of FiguresFigure 1. Typical 5V startup and operation current profile . . . . . . . . . . . . . . . . .

vi DiamondMax 21 PATA Product Manual, Rev. A

DiamondMax 21 PATA Product Manual, Rev. A 11.0 IntroductionThis manual describes the functional, mechanical and interface specifications for the follo