Maxtor STM31000528AS Betriebsanweisung PDF herunterladen (Seite 6)

Email: support@quadraplus.com Last Revised 12/11/20106

4.2.1 Record Speed Set the number of frames per second (fps).

PAL Default : 12 fps per channel. Maximum total frame: 50 fps.

Note: You can set 2 channels at 25fps but must clear 2 streams first.

4.2.2 Record QualityChoose video record quality: Highest, High, or Normal.

4.2.3 Event Record Duration5, 10, 15, 20, 25, 30 seconds. Default: 10 secs

4.2.4 Record Schedule Setup

4.2.4.1 Range: 0-24 hours.

4.2.4.2 Set “Red” for continuous recording.

4.2.4.3 Set “Grey” to disable the recording.

4.2.4.4 Set“Green” for motion recording.

4.3 Motion Detection Setup

4.3.1 Channel: The diagram above shows Channel 1.

4.3.2 Sensitivity: To set off, or 1 to 4, default: Off.

4.3.3 Alarm Duration: To set alarm duration when alarm is triggered by a moving

object: Off, 5, 10, 15, 20, 25, 30 seconds, or continuous.

4.3.4 Motion Area: To select motion detect area.

4.3.5 Smart RecordDefault is OFF. In normal condition, the system will record

the footage by using the setting of Normal Mode (Minimum recording frame

for each channel is 3fps); the smart recording mode will start as user’s setting

when motion or alarm has been triggered. If you want to enable motion

recording complete the setup procedure a and b.

aSet SENSITIVITY level from 1 ~ 4 in Motion Detection Setup.

bSet MOTION RECORDING to GREEN at the time you wish to enable

motion recording in Record Schedule.

Press  to select left/right;

Select  to change record status

Press  to change all

record status.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Keine Kommentare

Maxtor STM31000528AS Betriebsanweisung Seite 6