Maxtor 5T010H1 Bedienungsanleitung PDF herunterladen (Seite 25)

INSTALLATION

4 – 5

Install the Hard Drive in a Device BayInstall the Hard Drive in a Device Bay

Install the Hard Drive in a Device Bay

Refer to your computer user’s manual for specific mounting information. Be sure to secure the drive to the

device bay with all four screws.

Attach the Interface and Power CablesAttach the Interface and Power Cables

Attach the Interface and Power Cables

Do not force or rock the connectors into their sockets on the hard drive. Push them in straight until they

are seated.

Note: Maxtor Hard Drive Kits that carry an “H” in the kit number are Ultra ATA/100 compatible hard

drives. A standard IDE cable can be used for drive installation; however, an Ultra ATA cable is required to

achieve Ultra ATA/100 data transfers in Ultra ATA/100 compatible systems. Follow the illustration below for

proper cable connections to the system and hard drive(s) when using this cable.

Attach an IDE interface connector to J1 on the Maxtor drive. Attach a power connector to J2 on the

Maxtor drive. This connector is keyed and will only fit one way. Check all other cable connections before

you power up. Striped/colored edge is pin 1

After attaching the IDE interface cable and the

power cable to the Maxtor hard drive, verify that

all other cables connected to other devices, the

mother board or interface card(s) are correctly

seated.

Striped/colored edge is pin

Start upStart up

Start up

Turn your system ON. During the system start up sequence, run the SETUP (BIOS) program. Newer systems

usually display a message like “press DEL to enter Setup,” showing how to access the SETUP (BIOS) program.

Choose the device position where the Maxtor hard drive will be installed (Primary Master, Primary Slave,

Secondary Master, Secondary Slave or their equivalents) and select the “Auto Detect” option. Save and exit the

BIOS. The system will now boot. Boot to the MaxBlast™ Plus diskette.

Set upSet up

Set up

MaxBlast Plus will guide you through the steps to prepare (partition and format) your new Maxtor hard drive.

Once you have completed this step, your new Maxtor hard drive will be ready to use.

Note: Do not discard the MaxBlast Plus diskette once the installation is complete. The diskette contains Maxdiag,

a diagnostic utility that is a separate program from the MaxBlast Plus installation software.

Figure 4 - 4

IDE Interface and Power Cabling Detail

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Keine Kommentare

Maxtor 5T010H1 Bedienungsanleitung Seite 25