Maxtor Digital Multiplex Recorder Spezifikationen PDF herunterladen (Seite 6)

DVR16M 6 GB

c) Back Panel Description

1. LOOP connectors: bring the channel input signal out again to connect to an additional VCR, monitor etc.

2. VIDEO IN: to connect a video source such as a camera.

3. 75/HI switches: set these switches to the right position for the destination device when using the loop function.

4. POWER: connect the provided adapter to this connector and plug it into the mains.

5. External I/O: the device can be controlled remotely by an external device or trigger mechanism.

6. CALL: to connect a call monitor.

7. MONITOR: to connect the main monitor.

8. AUDIO IN: to connect an audio source such as a microphone (only when IPS is 15A for NTSC or 12A for PAL).

9. AUDIO OUT: to connect to a monitor or speaker system (only when IPS is 15A for NTSC or 12A for PAL).

25-pin COM port 9-pin COM port

PIN 1: GND: GROUND

PIN 2: ALARM INPUT 8: By connecting ALARM INPUT 8 (pin 2) to GND (pin 1), the DVR16M will start recording

and the buzzer will be on. Triggering depends on the set level (high/low) under Menu/Camera/Alarm.

PIN 3: ALARM INPUT 6: By connecting ALARM INPUT 6 (pin 3) to GND (pin 1), the DVR16M will start recording

and the buzzer will be on. Triggering depends on the set level (high/low) under Menu/Camera/Alarm.

PIN 4: ALARM INPUT 4: By connecting ALARM INPUT 4 (pin 4) to GND (pin 1), the DVR16M will start recording

and the buzzer will be on. Triggering depends on the set level (high/low) under Menu/Camera/Alarm.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Keine Kommentare

Maxtor Digital Multiplex Recorder Spezifikationen Seite 6